Rope – Water Detection Sensor

USD $425.00 – USD $445.00

- +
SKU: RWSC10 Categories: ,

Rope Water Sensor

Detect water leaks over a large area

Ideal for use in basements and under false floors and roof spaces, the Rope Water sensor can cover a large area.

  • Optional Lengths Available
  • Powered by the base unit

Additional information

Option

,

ropeWater Sensor

With the ropeWater sensor you can protect your essential equipment from potentially harmful water damage. Designed and manufactured by AKCP it forms an integral part of your solution for data center monitoring.

Ideal for use in basements and under false floors and roof spaces, the Rope Water sensor can cover a large area. Combined with any of our remote monitoring base units, or wireless tunnel sensors, it will give you advance notice of any water leaks or flooding.

The sensor will retain it’s error condition until it is read via an SNMP get. Therefore if the sensor encounters a critical condition at anytime it will report that condition before it returns to a normal state.

Specifications

Specifications

Measurement Range Wet or Dry
Sensor Type Open/Closed contact input switch
Measurement Rate Multiple readings every second
  Able to detect the presence or non-presence of water
Indication LED for Status
Operating Temperature -20 °C~60 °C
4 °F~140 °F
Pull Force Limit Not to exceed 50 lb
Bend Radius 2 in. (50 mm) minimum
Pressure Loads greater than 20 lb (9 kg) per linear inch at 20°C (68°F) may immediately trigger an alarm
   
Interface  
Communications Cable RJ-45 jack to sensor using UTP Cat 5 wire
Communications Cable Max. length The Rope Water Sensor can be extended from the RJ-45 Intelligent Sensor ports on the base units up to 100 feet, or 30 meters using standard CAT5/6 LAN cable.
Comes fully assembled including the Water sensing rope, the non-sensing cable that connects the rope to the sensing module and the main sensing module that connects via CAT5 LAN cable to the sensorProbe / securityProbe 5E.
Sensing rope cable can be pre-ordered from a 10 feet minimum to any custom run length of up to 165 feet or 50 meters.

Non-sensing cable comes in a standard 20 feet run length.
Power Source Powered by the controller unit. No additional power needed
  Full autosense including disconnect alarm
Power Consumption Typical 125 mWatt, 25 mA
Dimensions 56 x 55 x 33.3 mm
Mounting DIN rail mounting
Screw mounting
Important Note AKCP does not recommend the ropeWater Sensor to be placed on a conductive surface. 
Sensor count 1

Features

  • Ideal for covering large areas monitoring water leaks in warehouse and data centers
  • Compatible with sensorProbe, sensorProbe+ and securityProbe series
  • Protect water-sensitive equipment from disaster
  • Notifications via E-mail, SNMP trap, SMS and more
  • Comes in extendable 10ft lengths, or pre order custom length
  • Powered by the sensorProbe/securityProbe base unit, no additional power required
  • Will report critical state if cable is cut or damaged

3D View


View Separately

Often purchased with