Spot Water Leak Detection Sensor

USD $35.00 – USD $275.00

Clear
- +
SKU: WS15 Categories: ,

Spot Water Sensor

Protect your electronic equipment from water damage

The Spot Water Sensor is an advanced microprocessor-based design capable of detecting distilled water.

  • Additional Lengths Available
  • Powered by the base unit

Additional information

Option

, , ,

spotWater Detector

The Spot Water Sensor is an advanced microprocessor based design capable of detecting distilled water. Standard water detectors are unable to detect distilled water and water with other impurities due to them using a resistance type circuit. These resistance types rely on electrolytes present in the water, therefore being unable to detect distilled water due to it’s high resistance.

The entire circuit is encased in epoxy giving it a waterproof finish and able to withstand being submerged in water for prolonged periods. It has an SNMP OID for monitoring across a network, and will therefore report it’s critical condition at anytime before returning to it’s normal state.

Notifications can be sent to you via SNMP traps, or E-mail (sensorProbe base units) or using any of the wide range of alerts available on AKCP base units.

Specifications

Specifications

Measurement Range Wet or Dry
Sensor Type Open/Closed contact input switch
  Patent pending, microprocessor controlled, capacitance measurement technology
  Able to measure distilled water
Measurement Rate Multiple readings every second
Indication LED for Status
Operating Temperature -20 °C~60 °C
4 °F~140 °F
   
Interface  
Communications Cable RJ-45 jack to sensor using UTP Cat 5 wire
Communications Cable Max. length The Spot Water Sensor can be extended from the RJ-45 Intelligent Sensor ports on the base units up to 500 feet, or 150 meters using standard CAT5/6 LAN cable
Power Source Powered by the controller unit. No additional power needed
  Full autosense including disconnect alarm
Power Consumption Typical 65 mWatt, 13mA
Dimensions 55(W) x 39(H) x 27(D) mm
Mounting Screw mounting
Important Note AKCP does not recommend the spotWater Sensor to be placed on a conductive surface. If this is required, add the Insulation Coating P/N : WSIC to each spotWater Sensor ordered
Sensor count 1

Features

  • Detect presence of water
  • Works with securityProbe and sensorProbe series base units
  • Powered by the base unit, no additional power necessary
  • Maximum cable extension of 150m (500ft)
  • Even detects the presence of distilled water

3D View


View Separately

Often purchased with